Archive

10/25/2006 Electronic Design UPDATE: Can Equipment Manufacturers Afford To Reduce Standby Power?

Dec. 5, 2006

According to an Executive Order dated July 2001: "Each government agency, when it purchases commercially available, off-the-shelf products that use external standby power devices, or that contain an internal standby power function, shall purchase products

Sam Davis

Continue Reading

Solving the contact resistance challenge for 7nm and beyond CMOS

Flash Memory Takes Over

Sponsored Recommendations

TTI Transportation Resource Center

April 8, 2024

From sensors to vehicle electrification, from design to production, on-board and off-board a TTI Transportation Specialist will help you keep moving into the future. TTI has been...

Cornell Dubilier: Push EV Charging to Higher Productivity and Lower Recharge Times

April 8, 2024

Optimized for high efficiency power inverter/converter level 3 EV charging systems, CDE capacitors offer high capacitance values, low inductance (< 5 nH), high ripple current ...

TTI Hybrid & Electric Vehicles Line Card

April 8, 2024

Components for Infrastructure, Connectivity and On-board Systems TTI stocks the premier electrical components that hybrid and electric vehicle manufacturers and suppliers need...

Bourns: Automotive-Grade Components for the Rough Road Ahead

April 8, 2024

The electronics needed for transportation today is getting increasingly more demanding and sophisticated, requiring not only high quality components but those that interface well...