Debugger Stops Thread Groups

June 9, 2003

Green Hills Software's Multi debugger adds support for thread group breakpoints, along with a number of other new features. This comes in handy when dealing with multithreaded applications that interact with each other. The new run-mode JTAG debug support works with the ThreadX real-time operating system running on ARM7, ARM9, and ARM10 processors. The JTAG support works with the Green Hills Probe and Slingshot. These allow debugging while the processor continues to run.

www.ghs.com

Continue Reading

Solving the contact resistance challenge for 7nm and beyond CMOS

Flash Memory Takes Over

Sponsored Recommendations

TTI Transportation Resource Center

April 8, 2024

From sensors to vehicle electrification, from design to production, on-board and off-board a TTI Transportation Specialist will help you keep moving into the future. TTI has been...

Cornell Dubilier: Push EV Charging to Higher Productivity and Lower Recharge Times

April 8, 2024

Optimized for high efficiency power inverter/converter level 3 EV charging systems, CDE capacitors offer high capacitance values, low inductance (< 5 nH), high ripple current ...

TTI Hybrid & Electric Vehicles Line Card

April 8, 2024

Components for Infrastructure, Connectivity and On-board Systems TTI stocks the premier electrical components that hybrid and electric vehicle manufacturers and suppliers need...

Bourns: Automotive-Grade Components for the Rough Road Ahead

April 8, 2024

The electronics needed for transportation today is getting increasingly more demanding and sophisticated, requiring not only high quality components but those that interface well...