Electronic Design

Safety of Critical Connected Devices is Impossible Without Security (.PDF Download)

Sept. 22, 2016

Safety-critical developers traditionally haven’t concerned themselves with security. Typically, it’s not because it wasn’t important to them. Rather, their part was so deeply embedded into a larger system that there was no way to access it or make it do something outside of its intended operation mode...

Register or Sign in below to download the full article in .PDF format, including high-resolution graphics and schematics when applicable.

Download

Continue Reading

Solving the contact resistance challenge for 7nm and beyond CMOS

Use an LDO and PLD for Power-Supply Enable and Disable Functions

Podcast: How is Dragonfly’s new hover-in-place tethered UAV defying maritime communication limits?

In this podcast episode, we interview Joe Pawelczyk, VP of operations at DPI UAV Systems (USA), a leading provider of small rotary wing unmanned aerial vehicles (UAV).

LT8645/LT8646 Synchronous Step-Down Regulators

Analog Devices' LT8645 and LT8646 are 65 V, 8 A synchronous step-down/buck regulators. These regulators feature Silent Switcher architecture designed to minimize EMI/EMC emissions...

Automotive Radar Sensors - Transmit Signal Analysis and Inference Tests

This Application Note addresses signal measurements and analysis of automotive radars that are crucial during the development and verification stages.

LTC4296-1/LTC9111 SPoE/PD Controllers

ADI's LTC4296-1 is an IEEE 802.3cg-compliant, five port, Single-Pair Power over Ethernet (SPoE), PSE controller. SPoE simplifies system design and installation with standardized...