The Promise Of Harvested Energy

March 30, 2006
Nature possesses a boundless amount of harvestable energy that can be harnessed to power wireless sensor networks. Potentially, it can eliminate the need for batteries in tethered electronics and solve many power-supply and dissipation problem

Nature possesses a boundless amount of harvestable energy that can be harnessed to power wireless sensor networks. Potentially, it can eliminate the need for batteries in tethered electronics and solve many power-supply and dissipation problems in one stroke.

Vibration, strain and inertial forces, heat, wind, light, and magnetic fields can all be tapped for this purpose. Piezoelectric materials, for example, can convert mechanical motion into electric currents and vice versa. Magnetic and inductive coils can tap inertial forces. And, thermovoltaic and photovoltaic cells can harvest the energy given off by heat and light.

To successfully harvest energy, one must overcome formidable economic and reliability challenges. The battery industry is fast approaching performance limits in terms of materials and chemistry, which will pose another hurdle. But while the work on energy harvesting is only in its infancy, recent success in the laboratory shows that there's hope.

Perpetuum Ltd. and Innos Ltd. teamed up to develop embedded MEMS silicon microgenerators for wireless communications. The devices feed off the vibrations in the environment to produce consumable energy (see "Microgenerator Harvests Kinetic Energy For Wireless Devices," Electronic Design, Sept. 15, 2005, p. 28, ED Online 11050). Each 5- by 5- by 1.5-mm device can produce a few hundred microwatts of energy under certain conditions, which can drive sensors, small microprocessors, and RF transmitters for a complete self-powered system.

The University of Texas at Arlington's Materials Science and Engineering Department, meanwhile, has produced small piezoelectric-based generators to power wireless networks. Powered by 5- to 10-mph winds, the devices can produce up to 50 mW. That's enough to support individual nodes in a wireless sensor network.

The MIMOSA consortium has made energy harvesting—or energy " scavenging"—a major goal. So to that end, energy sources like photovoltaic cells, RF waves, and thermocouples are certainly worthy of investigation.

Sponsored Recommendations

TTI Transportation Resource Center

April 8, 2024
From sensors to vehicle electrification, from design to production, on-board and off-board a TTI Transportation Specialist will help you keep moving into the future. TTI has been...

Cornell Dubilier: Push EV Charging to Higher Productivity and Lower Recharge Times

April 8, 2024
Optimized for high efficiency power inverter/converter level 3 EV charging systems, CDE capacitors offer high capacitance values, low inductance (< 5 nH), high ripple current ...

TTI Hybrid & Electric Vehicles Line Card

April 8, 2024
Components for Infrastructure, Connectivity and On-board Systems TTI stocks the premier electrical components that hybrid and electric vehicle manufacturers and suppliers need...

Bourns: Automotive-Grade Components for the Rough Road Ahead

April 8, 2024
The electronics needed for transportation today is getting increasingly more demanding and sophisticated, requiring not only high quality components but those that interface well...

Comments

To join the conversation, and become an exclusive member of Electronic Design, create an account today!