Disk Controller/Read-Channel Family Handles The Gamut Of Power Requirements For Today's Portables

June 21, 2004
Circuits with performance tailored to meet almost every storage market segment—that's the driving force behind Agere's latest additions to its TrueStore family of disk-drive read channels and hard-disk controllers. Designers now have more...

Circuits with performance tailored to meet almost every storage market segment—that's the driving force behind Agere's latest additions to its TrueStore family of disk-drive read channels and hard-disk controllers. Designers now have more architectural flexibility to meet the repartitioned circuit requirements of new portable systems like MP3 players, digital cameras, and PDAs. These systems will use micro disk drives with diameters of 1.8 in. to less than 1 in. but still require exceptional signal integrity, high speed, and low power consumption.

The RC6700 read channel offers high-quality signal-to-noise ratio (SNR) and supports areal densities up to 160 Gbytes/platter for 3.5-in. drives targeting PCs, personal video recorders, gaming consoles, and set-top boxes. It operates at clock speeds in excess of 2 GHz, and servos operate 50% faster than the company's previous-generation desktop-level channel. For 2.5- and 1.8-in. drives in portable systems, the RC6700LP supports up to 80 Gbytes/platter while consuming 20% less power than the RC6700 and 40% less than Agere's previous-generation low-power channel.

When it comes to ultra-small form-factor drives, the RC1100ULP ultra-low-power channel helps extend battery life in 1- and sub-1-in. hard-disk drives. A "deep sleep" mode cuts the power drain by up to 70% compared to the RC6700LP. And, the RC7100HS delivers clock speeds in excess of 2.5 GHz to handle high-capacity, high-speed enterprise drives with spindle speeds up to 15k rpm that go into RAID arrays.

All four read channels share a common architecture that employs a digital finite-impulse-response filter. These channels support next-generation perpendicular recording techniques for both full and partial dc targets. The RC6700, RC6700LP, and RC7100HS are housed in 84-pin MLCC packages. The RC1100ULP comes in a 54-pin package.

An available drive controller provides the interface between host device and drive. Designed for mobile consumer designs, its initial version complements the RC1100ULP read channel for integration into a single-chip solution.

Engineering samples for most of the read-channel ICs are slated for the third quarter, with volume production due in the fall of 2004. The RC7100HS will be sampled in the fourth quarter, with volume production expected in 2005. Development versions of the hard-disk controller are expected in late 2004, with system-on-a-chip samples featuring the controller and the RC6700ULP read channel expected to ship in 2005.

Agere Systems Inc.www.agere.com
About the Author

Dave Bursky | Technologist

Dave Bursky, the founder of New Ideas in Communications, a publication website featuring the blog column Chipnastics – the Art and Science of Chip Design. He is also president of PRN Engineering, a technical writing and market consulting company. Prior to these organizations, he spent about a dozen years as a contributing editor to Chip Design magazine. Concurrent with Chip Design, he was also the technical editorial manager at Maxim Integrated Products, and prior to Maxim, Dave spent over 35 years working as an engineer for the U.S. Army Electronics Command and an editor with Electronic Design Magazine.

Sponsored Recommendations

Comments

To join the conversation, and become an exclusive member of Electronic Design, create an account today!