Metering ICs

Dec. 2, 2003
Analog Devices’ new energy metering ICs—the ADE7753 and ADE7758—are based on the company’s high-resolution analog-to-digital converter (ADC) technologies,
Analog Devices’ new energy metering ICs—the ADE7753 and ADE7758—are based on the company’s high-resolution analog-to-digital converter (ADC) technologies, combined with a fixed-function DSP. The DSP performs all the necessary energy measurement calculations, allowing a low-cost microprocessor to be used for data management and supervisory functions. This architecture simplifies meter designs that previously relied on microprocessors to perform complex computations. The reduction in extensive code development significantly reduces cost and time-to-market.

The ADE7758, which features second-order sigma-delta ADCs, is designed for midrange 3-phase energy meters. For each phase, the chip measures reactive, active, and apparent energy; as well as rms voltage and rms current. These measurements are accessed via a serial interface that allows a fully automated digital calibration. The ADE7758 interfaces with a variety of sensors, including current transformers and di/dt current sensors, such as Rogowski coils. Like other products in the ADE family, the ADE7758 provides accurate active energy measurements with less than 0.1% gain error over a current dynamic range of 1000-to-1. Its reactive energy measurement also surpasses the Class 2 IEC61268 accuracy requirement of VAR-hr meters.

For more information, visit www.analog.com/ADE7753 or www.analog.com/ADE7758.

Sponsored Recommendations

TTI Transportation Resource Center

April 8, 2024
From sensors to vehicle electrification, from design to production, on-board and off-board a TTI Transportation Specialist will help you keep moving into the future. TTI has been...

Cornell Dubilier: Push EV Charging to Higher Productivity and Lower Recharge Times

April 8, 2024
Optimized for high efficiency power inverter/converter level 3 EV charging systems, CDE capacitors offer high capacitance values, low inductance (< 5 nH), high ripple current ...

TTI Hybrid & Electric Vehicles Line Card

April 8, 2024
Components for Infrastructure, Connectivity and On-board Systems TTI stocks the premier electrical components that hybrid and electric vehicle manufacturers and suppliers need...

Bourns: Automotive-Grade Components for the Rough Road Ahead

April 8, 2024
The electronics needed for transportation today is getting increasingly more demanding and sophisticated, requiring not only high quality components but those that interface well...

Comments

To join the conversation, and become an exclusive member of Electronic Design, create an account today!