Compute Low-Frequency Parameters of Resistive Attenuators with Three DC-Resistance Measurements (.PDF Download)

Feb. 21, 2017

While a network analyzer is normally used to measure attenuator characteristics, all low-frequency attenuator parameters may be derived from just three measurements of dc resistance. Figure 1 shows the tee (T) representation of the attenuator; note that the pi (π) representation can also be used, but requires more complex calculations...

Register or Sign in below to download the full article in .PDF format, including high-resolution graphics and schematics when applicable.

Sponsored

Explore Raspberry Pi’s imaging and AI tools in this free webinar with expert insights from Naushir Patuck. Register now to attend live or watch the recording later.
Whether you’re a beginner or an enthusiast, our free pocket guide, spanning roughly 60 pages, offers a broad insight into satellite technologies in one handy place. From clear...
This white paper describes the basic functionality of antennas. Starting with Hertz's Antenna model followed by a short introduction to the fundamentals of wave propagation, the...
TE Connectivity AMP’s mezzanine connectors include Micro MaTch, Free Height & MICTOR SB connectors all available at Digi-Key. Same day shipping!