Logic-Level Signals Shifted To Dim -48-V LED Driver

Here's a circuit using Maxim's MAX16822A 65-V LED driver to provide dimming control in -48 V telecommunication systems.
June 25, 2009
2 min read

The main source of power in a telecommunications system is -48 V. This source’s negative polarity and its large magnitude with respect to ground pose a challenge when designers want to use low-power ICs in the telecom system’s application circuits. Fortunately, the emergence of high-voltage ICs—with operating voltages of 75 V and higher—has enabled the use of simple biasing techniques in designing circuits for -48-V systems.

The technique described here provides a dimming control for an LED. The circuit uses a 65-V hysteretically controlled LED driver (MAX16822A) with its ground pin connected to -48 V and its power input connected to the system ground (Fig. 1). For proper dimming, therefore, the circuit’s logic-level control signal (at Control) must be level-shifted down to -48 V and applied to the DIM input. The high-voltage pnp transistor (CMPT5551) (80 V/500 mA) enables a simple solution to that problem.

The transistor circuit is made to operate at approximate unity gain by setting R1 equal to R2. With the control input at 0 V, the transistor is biased at cut-off, pulling the collector (connected to DIM) down to -48 V. With the control input at 5 V, the collector pulls up to -43 V. Thus, the ground-referenced 0- to 5-V dimming signal at the control input is replicated at DIM, but referenced to the -48-V rail. Figure 2 shows the circuit’s average LED current versus pulse-width modulation (PWM) duty cycle.

About the Author

Sign up for Electronic Design Newsletters
Get the latest news and updates.

Voice Your Opinion!

To join the conversation, and become an exclusive member of Electronic Design, create an account today!