Cables Deliver DC Power

April 1, 1999

Including right-angle or straight molded plugs, these molded dc power plugs and cords can be assembled using various wire gauges and UL-approved wire, as well as in outer diameters of 3.5, 4, 5.5 or 6 mm for 0.8, 0.9, 1, 1.3, 1.7, 2 or 2.5 mm pin sizes. Standard products are available now with no minimums, and custom products are available in six to eight weeks with minimum lot sizes of 2500 units.

Sponsored Recommendations

TTI Transportation Resource Center

April 8, 2024
From sensors to vehicle electrification, from design to production, on-board and off-board a TTI Transportation Specialist will help you keep moving into the future. TTI has been...

Cornell Dubilier: Push EV Charging to Higher Productivity and Lower Recharge Times

April 8, 2024
Optimized for high efficiency power inverter/converter level 3 EV charging systems, CDE capacitors offer high capacitance values, low inductance (< 5 nH), high ripple current ...

TTI Hybrid & Electric Vehicles Line Card

April 8, 2024
Components for Infrastructure, Connectivity and On-board Systems TTI stocks the premier electrical components that hybrid and electric vehicle manufacturers and suppliers need...

Bourns: Automotive-Grade Components for the Rough Road Ahead

April 8, 2024
The electronics needed for transportation today is getting increasingly more demanding and sophisticated, requiring not only high quality components but those that interface well...


To join the conversation, and become an exclusive member of Electronic Design, create an account today!