Low-Profile Battery Clips Eye High-Density AAA And N Sizes

Sept. 29, 2003
New low-profile clips for AAA and N batteries are a good fit for high-density applications. They feature a "flow-through" surface-mount solder tail for increasing joint strength and a 0.10-in. nickel-plated steel spring clip for secure battery...

New low-profile clips for AAA and N batteries are a good fit for high-density applications. They feature a "flow-through" surface-mount solder tail for increasing joint strength and a 0.10-in. nickel-plated steel spring clip for secure battery retention and shock and vibration resistance. They come in loose-piece packaging (part #55) or on tape and reel (part #55TR) with 300 pieces/13.0-in. reel. The polysterene carrier tape meets ANSI/EIA-481 standards. It's 32 mm wide with parts mounted on a 16-mm pitch that's compatible with most vacuum and mechanical pick-and-place assembly systems. Prices start at $6 per hundred for bulk quantities with delivery from stock.

Keystrone Electronics Corp.www.keyelco.com; (800) 221-5510

About the Author

Roger Allan

Roger Allan is an electronics journalism veteran, and served as Electronic Design's Executive Editor for 15 of those years. He has covered just about every technology beat from semiconductors, components, packaging and power devices, to communications, test and measurement, automotive electronics, robotics, medical electronics, military electronics, robotics, and industrial electronics. His specialties include MEMS and nanoelectronics technologies. He is a contributor to the McGraw Hill Annual Encyclopedia of Science and Technology. He is also a Life Senior Member of the IEEE and holds a BSEE from New York University's School of Engineering and Science. Roger has worked for major electronics magazines besides Electronic Design, including the IEEE Spectrum, Electronics, EDN, Electronic Products, and the British New Scientist. He also has working experience in the electronics industry as a design engineer in filters, power supplies and control systems.

After his retirement from Electronic Design Magazine, He has been extensively contributing articles for Penton’s Electronic Design, Power Electronics Technology, Energy Efficiency and Technology (EE&T) and Microwaves RF Magazine, covering all of the aforementioned electronics segments as well as energy efficiency, harvesting and related technologies. He has also contributed articles to other electronics technology magazines worldwide.

He is a “jack of all trades and a master in leading-edge technologies” like MEMS, nanolectronics, autonomous vehicles, artificial intelligence, military electronics, biometrics, implantable medical devices, and energy harvesting and related technologies.

Sponsored Recommendations

Comments

To join the conversation, and become an exclusive member of Electronic Design, create an account today!