Comparator-Based Circuits Easily Shift Voltage Level, Flip Polarity

BUDGE ING, Maxim Integrated Products Inc., Sunnyvale, Calif. [email protected] Because digital systems often have only a single-polarity power supply, a common problem becomes translating an opposite-polarity pulse train into a positive-or neg
June 22, 2006
2 min read

BUDGE ING, Maxim Integrated Products Inc., Sunnyvale, Calif.
[email protected]

Because digital systems often have only a single-polarity power supply, a common problem becomes translating an opposite-polarity pulse train into a positive-or negative-pulse output. Here are some simple circuits that can do the job easily and reliably.

For positive-supply systems, the circuit of Figure 1a transforms a negative pulse train into positive-going output pulses. The dual-output comparator provides both inphase and out-of-phase outputs. (If the system requires only one output phase, you can substitute an alternative single-output comparator.) Voltage at the comparator's inverting input swings between 1.8 and 3.0 V. Also, making R1 = R2 sets the noninverting input voltage to 2.5 V. As configured here, the complementary comparator outputs produce positive pulse trains.

For negative-supply systems, the circuit of Figure 1b (which is very similar to that of Figure 1a) transforms a positive pulse train into negative-going output pulses. Voltage at the comparator's inverting input ranges between 1.8 and 3.0 V, and setting R1 = R2 makes the noninverting input voltage equal to 2.5 V. In this instance, the complementary comparator outputs generate negative pulse trains.

In the circuits of Figure 2 and Figure 3, the comparator serves as a buffer, thereby providing an interface configuration for systems whose input signal and system supply voltage are of opposite polarity. The Figure 2 circuit enables a system with positive supply voltage to accept negative pulses. Similarly, the Figure 3 circuit lets a system with negative supply voltage handle positive input signals. Both circuits use npn transistors to levelshift the comparator's outputs by:

\[VBE(R5 + R4)\]/R5 ≈ 4.5 V

For single-phase outputs, you can choose a suitable single-output comparator.

About the Author

Sign up for Electronic Design Newsletters
Get the latest news and updates.

Voice Your Opinion!

To join the conversation, and become an exclusive member of Electronic Design, create an account today!