Rohde & Schwarz Adds LTE-Advanced Carrier Aggregation to R&S CMW500
February 6, 2013. Rohde & Schwarz has equipped its R&S CMW500 wideband radio communication tester with new software options for LTE-Advanced downlink carrier aggregation. Carrier aggregation allows network operators to create flexible combinations of frequency bands of different bandwidths and make even better use of the spectrum. In the downlink, wireless devices in an LTE-Advanced network are connected with two cells simultaneously. As a result, an extremely high data rate of up to 300 Mbps in the downlink has been achieved in the initial rollout phase of LTE-Advanced carrier aggregation with 40-MHz total bandwidth. Current LTE networks have a maximum bandwidth of 20 MHz.
The R&S CMW500 makes it possible for the developers of chipsets used in tomorrow's wireless devices to carry out the tests defined in LTE-Advanced Release 10. These include verification tests on the physical layer and the protocol stack as well as throughput tests. Any potential scenario a network operator might need to test can be configured in the lab. All combinations of defined bands and bandwidths for LTE-Advanced can be tested with two downlink carriers, including MIMO 2×2 and 4×2. The R&S CMW500 emulates the two cells used in an LTE-Advanced network. By combining two R&S CMW500, it is also possible to test the handover within LTE-Advanced networks. This way, developers can verify the behavior of wireless devices in an LTE Release 10 network with continuous coverage via downlink carrier aggregation. The solution is aimed not only at chipset makers but also helps developers of wireless devices integrate chipsets supporting LTE-Advanced into their products. This allows network operators to perform acceptance tests for wireless devices.
Developers who are already using the R&S CMW500 multistandard test platform as a protocol tester for LTE and WCDMA Releases 8 and 9 equipment can easily upgrade their instrument to include LTE-Advanced carrier aggregation. The instrument also supports earlier digital wireless communications standards such as GSM and WCDMA, making it ideal for InterRAT handover simulations.
The R&S CMW-KP594, -KF513 and -KF514 software options for LTE-Advanced downlink carrier aggregation are now available from Rohde & Schwarz. Rohde & Schwarz will present the test solution at the Mobile World Congress February 25-28 in Barcelona.