ZigBee SoC Doubles Transmission Range

Feb. 2, 2006
The EM-250 system-on-a-chip (SoC) packs a host of features that fit ZigBee applications. Developed by Ember Corp., this radio includes a 2.4-GHz transceiver, the low-power XAP2 16-bit processor, 128 kbytes of flash memory, 5 kbytes of RAM, a

The EM-250 system-on-a-chip (SoC) packs a host of features that fit ZigBee applications. Developed by Ember Corp., this radio includes a 2.4-GHz transceiver, the low-power XAP2 16-bit processor, 128 kbytes of flash memory, 5 kbytes of RAM, and the ZigBee stack software. It also fully complies with IEEE 802.15.4.

Derived from work done at Cambridge Consultants, this fourth-generation chip doubles the range of previous Ember devices and competitive products. In fact, Ember chairman and Ethernet inventor Bob Metcalfe challenges designers to compare the EM-250 with competitive chips!

The EM-250 offers a ?94-dBm receive sensitivity and transmit power to +4 dBm. Its adjacent channel rejection is less than 30 dB, and its alternative channel rejection is less than 40 dB. Operating from a 2.1- to 3.6-V supply, it only requires a 24-MHz crystal and the LC network for antenna matching. It comes in a 7- by 7-mm, 48-pin quad leadless package.

An alternate version, the EM-260, is configured so designers can use a microcontroller of their own choosing to run their application. It incorporates a serial peripheral interface and acts as the slave to the customer's microcontroller master. The EM-260 also supports a standard UART interface. It comes in a 6- by 6-mm, 40-pin quad-flat-nonleaded chip.

A development kit with all the latest software and hardware is available as well (see the figure).

Ember Corp.
ww.ember.com

Sponsored Recommendations

The Importance of PCB Design in Consumer Products

April 25, 2024
Explore the importance of PCB design and how Fusion 360 can help your team react to evolving consumer demands.

PCB Design Mastery for Assembly & Fabrication

April 25, 2024
This guide explores PCB circuit board design, focusing on both Design For Assembly (DFA) and Design For Fabrication (DFab) perspectives.

What is Design Rule Checking in PCBs?

April 25, 2024
Explore the importance of Design Rule Checking (DRC) in manufacturing and how Autodesk Fusion 360 enhances the process.

Unlocking the Power of IoT Integration for Elevated PCB Designs

April 25, 2024
What does it take to add IoT into your product? What advantages does IoT have in PCB related projects? Read to find answers to your IoT design questions.

Comments

To join the conversation, and become an exclusive member of Electronic Design, create an account today!