Gbit Interface Converter Has Signal Detect Feature

June 1, 1999

Equipped with signal detect and in-rush current limiting capabilities is the blind mate, hot-pluggable Active Copper Gigabit Interface Converter (GBIC), which is fully compliant with GBIC spec Rev. 5.1. The signal detect feature provides enhanced performance in applications where low receiver sensitivity makes noise and issue. The 20-position, SCA-2 pc board interface meets GBIC spec 4.5. The six-position HSSDC I/O connector is documented by the Fibre Channel Ph-3 spec. Connections via copper HSSDC cables are supported for distances up to 30 meters. Applications are found in clustered workstations, servers, hubs and switches.

Sponsored Recommendations

TTI Transportation Resource Center

April 8, 2024
From sensors to vehicle electrification, from design to production, on-board and off-board a TTI Transportation Specialist will help you keep moving into the future. TTI has been...

Cornell Dubilier: Push EV Charging to Higher Productivity and Lower Recharge Times

April 8, 2024
Optimized for high efficiency power inverter/converter level 3 EV charging systems, CDE capacitors offer high capacitance values, low inductance (< 5 nH), high ripple current ...

TTI Hybrid & Electric Vehicles Line Card

April 8, 2024
Components for Infrastructure, Connectivity and On-board Systems TTI stocks the premier electrical components that hybrid and electric vehicle manufacturers and suppliers need...

Bourns: Automotive-Grade Components for the Rough Road Ahead

April 8, 2024
The electronics needed for transportation today is getting increasingly more demanding and sophisticated, requiring not only high quality components but those that interface well...

Comments

To join the conversation, and become an exclusive member of Electronic Design, create an account today!