Tdk Qm

700- to 1,500-W modular power supplies have PMBus interface

July 27, 2017

TDK Corp. has announced the introduction of a PMBus communications interface option card for the 700- to 1,500-W QM Series modular power supplies. The PMBus (Power Management Bus) option is an open standard digital power management protocol, allowing power devices to communicate with each other. The QM power supplies are available with up to 16 outputs, have full medical MoPPs isolation, and exhibit low acoustic noise.

The addition of PMBus allows the user or system to remotely turn the QM power supplies on and off (inhibit or enable mode) as well as read back their incoming air temperatures, total operating hours, fan speed, fan status, and manufacturing details. Up to eight QM power supplies can be connected to one controller. Included on the option card is a 5-V, 2-A standby output (always on) and a “Fan Fail” signal output. In the event of the fan slowing due to bearing wear, or running fast because the inlet air is restricted, the signal (and interface bus) will indicate that preventative maintenance is required, avoiding costly unplanned equipment downtime.

The communications option can be selected when using the TDK-Lambda “Product Quick Finder” configuration tool. This web-based tool allows users to enter their desired output voltages and currents, select any options, and be provided with an eight-digit code for simplified quoting and ordering purposes. The program will automatically select the optimum product and configuration.

http://www.us.tdk-lambda.com/lp/products/qm- series.htm

About the Author

RN (editor)

This post was selected and edited by Executive Editor Rick Nelson from a press release or other news source. Send relevant news to [email protected].

Sponsored Recommendations

Comments

To join the conversation, and become an exclusive member of Electronic Design, create an account today!