Tester Packs Power Quality Analyzer, Multimeter And Scope

Nov. 1, 1998

A power quality analyzer, multimeter and oscilloscope have been combined into one instrument to assist users in troubleshooting power problems and diagnosing equipment failures. Well-suited for making measurements on 600V Category III installations and employing separate voltage and current inputs to optimize these measurements, Fluke 43 Power Quality Analyzer can record and save up to 40 transients or distorted waveforms and correlate the cause of distortion to time and date.The tester's analyzer function is designed to measure voltage, current and power harmonics, total harmonic distortion, and the phase angle of individual harmonics. The scope can capture signals of up to 20 MHz. The 2.5 lb., 9.1" x 4.5" x 2" meter comes with probes and software.

Sponsored Recommendations

TTI Transportation Resource Center

April 8, 2024
From sensors to vehicle electrification, from design to production, on-board and off-board a TTI Transportation Specialist will help you keep moving into the future. TTI has been...

Cornell Dubilier: Push EV Charging to Higher Productivity and Lower Recharge Times

April 8, 2024
Optimized for high efficiency power inverter/converter level 3 EV charging systems, CDE capacitors offer high capacitance values, low inductance (< 5 nH), high ripple current ...

TTI Hybrid & Electric Vehicles Line Card

April 8, 2024
Components for Infrastructure, Connectivity and On-board Systems TTI stocks the premier electrical components that hybrid and electric vehicle manufacturers and suppliers need...

Bourns: Automotive-Grade Components for the Rough Road Ahead

April 8, 2024
The electronics needed for transportation today is getting increasingly more demanding and sophisticated, requiring not only high quality components but those that interface well...

Comments

To join the conversation, and become an exclusive member of Electronic Design, create an account today!