Cellphonel Antenna Thinkstock

Cascadable Gain Blocks Support Sub-10-GHz Designs

Oct. 26, 2022
The intermediate-stage gain blocks, positioned within the RF signal chain, are easily interfaced and even cascaded if needed.

Components that support the last stage of the transmit-side RF signal chain and the first stage of receive-side complement—namely, the power amplifier (PA) and low-noise amplifier (LNA), respectively—get lots of attention for many reasons. However, internal intermediate gain stages in the signal chain also require their perhaps less-acknowledged components.

Addressing this gap, the CMX90G301 and CMX90G302 positive gain-slope amplifiers from CML Microcircuits are general-purpose gain blocks (Fig. 1). They’re well-suited to a wide range of wireless applications operating in the 1.4- to 7.1-GHz frequency range, including 4G/5G infrastructure applications and devices operating in license-free bands.

The CMX90G301 has +1-dB positive-gain slope, while the very similar CMX90G302 offers a +2-dB gain slope for applications requiring more gain-slope compensation. Both devices deliver a small-signal gain of 14.8 to 16.0 dB, a P1dB output rating of +11.5 dBm at 3.5 GHz, and a low noise figure of 2 dB. GaAs pHEMT technology is used to achieve an optimal combination of low dc power, low noise, and high gain.

Among the many graphs on the datasheet are those for basic performance of key parameters of small-signal gain, noise figure, P1dB output, and OIP3 (Fig. 2).

The CMX90G301 and CMX90G302 gain blocks are designed for ease of use, with a high level of integration and minimal need for supporting components, resulting in reduced PCB footprint as seen in the application schematic (Fig. 3). They eliminate the need for passive equalization circuits within the system design.

Further, due to their on-board active-bias circuit, the devices operate over a wide supply voltage of 2.7 to 5 V with a typical current of 22 mA. On top of that, the RF ports of each device are matched to 50 Ω, supporting rapid product development cycles, particularly for mass-market applications.

The datasheet also defines details of the 20- × 45-mm EV90G301 evaluation board, inducing the short bill of materials, top layer of PCB (Fig. 4), and even a cross section calling out the critical aspects of the layer stack of the PCB. 

Both parts are housed in 3- × 3-mm VQFN-16 packages.

Sponsored Recommendations

TTI Transportation Resource Center

April 8, 2024
From sensors to vehicle electrification, from design to production, on-board and off-board a TTI Transportation Specialist will help you keep moving into the future. TTI has been...

Cornell Dubilier: Push EV Charging to Higher Productivity and Lower Recharge Times

April 8, 2024
Optimized for high efficiency power inverter/converter level 3 EV charging systems, CDE capacitors offer high capacitance values, low inductance (< 5 nH), high ripple current ...

TTI Hybrid & Electric Vehicles Line Card

April 8, 2024
Components for Infrastructure, Connectivity and On-board Systems TTI stocks the premier electrical components that hybrid and electric vehicle manufacturers and suppliers need...

Bourns: Automotive-Grade Components for the Rough Road Ahead

April 8, 2024
The electronics needed for transportation today is getting increasingly more demanding and sophisticated, requiring not only high quality components but those that interface well...


To join the conversation, and become an exclusive member of Electronic Design, create an account today!