Cascadable Gain Blocks Support Sub-10-GHz Designs

Components that support the last stage of the transmit-side RF signal chain and the first stage of receive-side complement—namely, the power amplifier (PA) and low-noise amplifier (LNA), respectively—get lots of attention for many reasons. However, internal intermediate gain stages in the signal chain also require their perhaps less-acknowledged components.

Addressing this gap, the CMX90G301 and CMX90G302 positive gain-slope amplifiers from CML Microcircuits are general-purpose gain blocks (Fig. 1). They’re well-suited to a wide range of wireless applications operating in the 1.4- to 7.1-GHz frequency range, including 4G/5G infrastructure applications and devices operating in license-free bands.

1. The CML CMX90G301 and CMX90G302 are easy-to-use intermediate-stage amplifiers for the 1.4- to 7.1-GHz frequency range.

The CMX90G301 has +1-dB positive-gain slope, while the very similar CMX90G302 offers a +2-dB gain slope for applications requiring more gain-slope compensation. Both devices deliver a small-signal gain of 14.8 to 16.0 dB, a P1dB output rating of +11.5 dBm at 3.5 GHz, and a low noise figure of 2 dB. GaAs pHEMT technology is used to achieve an optimal combination of low dc power, low noise, and high gain.

Among the many graphs on the datasheet are those for basic performance of key parameters of small-signal gain, noise figure, P1dB output, and OIP3 (Fig. 2).

2. The datasheets provide needed performance graphs such as these for the CMX90G301 under defined conditions.

The CMX90G301 and CMX90G302 gain blocks are designed for ease of use, with a high level of integration and minimal need for supporting components, resulting in reduced PCB footprint as seen in the application schematic (Fig. 3). They eliminate the need for passive equalization circuits within the system design.

3. The evaluation-board schematic shows the few passive external components required to use the amplifiers.

Further, due to their on-board active-bias circuit, the devices operate over a wide supply voltage of 2.7 to 5 V with a typical current of 22 mA. On top of that, the RF ports of each device are matched to 50 Ω, supporting rapid product development cycles, particularly for mass-market applications.

The datasheet also defines details of the 20- × 45-mm EV90G301 evaluation board, inducing the short bill of materials, top layer of PCB (Fig. 4), and even a cross section calling out the critical aspects of the layer stack of the PCB.